Sediment filter - Against rust, dirt and limescale

Filter fineness: 5 µm (sediment: rust, sand, dirt, lime particles)
Material (filter medium): PP (melt-blown) , food-safe
Weight (filter): 0.052g
Capacity/service life: approx. 1-2 months (depending on water quality)
Compatibility: suitable for Elekshower
Origin: PRC Developed in: Germany

Depending on showering habits and water quality, approximately 1–2 months . If the water is very hard or cloudy, you may need to replace it sooner.

A notice:
Change the filter sooner if the water pressure decreases, the filter becomes heavily discolored, or the water smells unusual.

1. Unscrew the old shower head. Check the seal on the hose and replace it if necessary.
   
2. Screw on the new shower head. Tighten by hand (1/4 turn is sufficient).
   
3. Test for leaks. Briefly turn on the water. If it drips, position the seal correctly or apply 1-2 layers of PTFE tape to the ½" thread.
   

B. Insert/change filter

1. Turn off the water. Disconnect the shower head from the hose or open the filter chamber (depending on the model).
   
2. Open the housing. Carefully unscrew the transparent filter compartment.
   
3. Remove the old filter and rinse the housing. Check the O-ring/seal, and clean with clean water if necessary.
   
4. Install the new sediment filter. If a flow direction is marked, install it accordingly.
   
5. Position the seal correctly and screw the chamber back on – hand-tight only (do not tilt).
   
6. Flush: Install shower head, let water run for 30-60 seconds until the water runs clear.
   

C. Care & change interval

• Change: every 4–8 weeks (approx. 1–2 months ) – depending on water quality and frequency of showering .
  
• Change early if the water pressure decreases or the filter becomes heavily discolored .